Water - Articles - Page 161

Pulling a Submersible Pump the Old Way - By Hand

March 1, 2016

Readers, you will have to forgive me, for I am going to take a short detour from my series of columns about clamp-on pitlesses. I recently had occasion to pull a pump that I had installed years ago and, not having a pump hoist available, did it the way we used to do it.

Applus RTD Drilling Job to Help Future Subsurface Research

New Water Wells Drilled at State University of New York

February 10, 2016

No Comments

The installation of new wells at a New York university will support the study of groundwater tracing.

NG225, NG295 Doosan Generators Now Built for Paralleling

Paralleling Allows Generators to Share the Load

February 2, 2016

No Comments

The factory-installed paralleling solution decreases downtime and increases machine reliability.

Drilling Big Wells in Small Spaces

Valerie King

February 1, 2016

No Comments

Drilling large commercial and municipal wells in cramped quarters is not for everyone.

Water Well Drilling Veteran Porky Cutter Turns 80

Howard "Porky" Cutter MGWC

February 1, 2016

No Comments

This month, I will turn 80 years old. For most of these years, I have been involved in drilling of some type.

For Charity Drilling Jobs, Safety Secures Success

Joe Haynes

February 1, 2016

No Comments

Though we often take clean water for granted, millions around the country are not so lucky, and that daily convenience is replaced by a deep longing for fresh, clean, convenient water.

Another Chapter on Pitless Adapters

John Schmitt

February 1, 2016

No Comments

As I write these columns and think about different subjects, I seem to have more to say about certain procedures and products used in our industry than others.